H8, H11 resistor - CAN error decoder 50W 6 Ohm 12V

H8, H11 resistor - CAN 50W 6 Ohm error decoder 12V

Dedicated to H8, H11, PGJ19 / 1, PGJ19 / 2 bulbs. Plug 'n Play version. It is enough to connect to the bulb socket and attach the resistor to the metal element so that it does not break off while driving. Nothing needs to be soldered, etc. Quick assembly, eliminates errors.

A 50W 6 Ohm resistor with a heat sink eliminating any problems related to the use of LED bulbs in cars with the CANBUS system. The use of a resistor is often necessary even when using bulbs marked with CANBUS in cars where the CAN system is particularly sensitive - e.g. Audi A4 B7. It is also necessary to use them in VAG group cars after 2009, Octavia 2 FL (> 2009), Leon 2 (> 2010), Golf6, etc.

After using the resistor, you can use cheaper LED bulbs - errors will not appear anymore.

• Purpose: H8, H11 bulbs are most often used as fog lights, low beam, high beam.

Resistor for light bulbs up to 55W (it is the power of a traditional light bulb) when replacing light bulbs with a power of up to 21W, use a 25W 6 Ohm resistor.

Installation outside the lamp, we do not cut the cables, but just connect one end of the resistor to the plus and the other to the minus (we are talking about the cables powering the LED bulb), as if we wanted to make a short circuit with this resistor. The resistor should be attached to a metal element so that it does not break off while driving and has better cooling.

Each product is individually checked prior to shipment.

Certificates: CE